3 Manual search Searches for projectors on the network by specifying the projector's
IP address or projector name.
4 Profile Searches for projectors on the network by using the projector
information saved previously.
5 Profile list Displays the registered profiles (projector information). When you
double-click the profile, the projectors registered in the profile are
searched for on the network.
6 Set options Displays the Set options screen.
7 Join Connects to the selected projectors.
8 List of Connected Displays information on the projectors selected from the Projector
Projectors List. Even if the search method is changed, the content of the List of
Connected Projectors remains the same.
9 Register Registers the projectors from the List of Connected Projectors to a
profile.
10 Connect as Moderator Connects to the selected projectors as the moderator (supported
models only).
The moderator function may not be available on all versions of this
software.
11 Clear list Clears information displayed in the Projector List and the List of
Connected Projectors.
12 Projector List Displays a list of the projectors found on the network. You can then
select projectors to connect to. The search results for each search
method (Automatic search, Manual search, and Profile) are
displayed in separate lists.
Status See the description of projector status icons
in the next table.
Projector name Displays the projector's name.
IP address Displays the projector's IP address.
Comments Displays comments for the projector. You can
edit the comment by right-clicking the profile,
and then clicking Property. You can enter up
to 32 characters.
13 Refresh Updates information in the Projector List.
63