Troubleshooting
46
The selected projector is busy. Do you want to continue
the connection process?
You tried to connect to a projector that is connected to another computer.
When Yes is clicked, it connects to the projector. The connection between the projector and the other
computer is cut off.
When No is clicked, it does not connect to the projector. The connection between the projector and
the other computer is maintained.
EasyMP Network Projection initialization failed. Restart EasyMP Network Projection. If the message still appears, uninstall and then reinstall EasyMP
Network Projection.
s "Installing" p.7
Connection failed due to keyword mismatch. When connecting to a projector for which a Projector Keyword has been set, the wrong Projector
Keyword is entered.
Check the Projector Keyword that is displayed on the LAN standby screen.
s "Operating the Computer" p.11
Network adapter information could not be obtained. Check the following point.
• Is a network adapter installed on the computer?
• Is the driver for the network adapter used installed on the computer?
• Is the network adapter enabled?
After checking, restart the computer and connect again.
If you still cannot connect, check the following.
Check the network settings on the computer and the network settings on the projector.
You can make network settings from the projector's Network menu.
See your projector User’s Guide for details.
One or more connected projectors do not support
resolutions greater than SXGA. Reduce the screen
resolution and reconnect.
There is an incompatible projector in the connection destination. Change the computer screen
resolution to SXGA (1280x1024) or less.
One or more projectors are not responding. Failed to simultaneously connect to one or more of the projectors that you attempted to connect to.
Check the network settings on the computer and the network settings on the projector.
You can make network settings from the projector's Network menu.
See your projector User’s Guide for details.
Error Messages Remedy
To Next Page
Loading...
Need help?
General