You must enter the correct password to use the projector.
1. Hold down the Num button on the remote control while you enter the password using the numeric
buttons.
The password screen closes.
2. If the password is incorrect, the following may happen:
• You see a "wrong password" message and a prompt to try again. Enter the correct password to
proceed.
• If the password is incorrect three times, you see a message that the projector is locked and a
request code. Write down the code, turn the projector off, and disconnect the power cord from the
projector. Then reconnect the power cord, turn the projector back on, and enter the password
again.
98
To Next Page
Loading...
Need help?
General