Epson PowerLite W16SK - Page 14

Superimposing the
images from the
commander and the
receiver
Perform this procedure
after setting up the
projectors.
Projecting
Images
Press the [ ] button on the
commander's control panel.
The commander and the receiver
turn on.
Hold down the [Screen Fit] button for about ve seconds.
The initial adjustment screen and the white and green
frames are displayed.
1
Open the A/V mute
slides.
Open the A/V mute slides on the
commander and the receiver.
2
Turn on the projectors.
3
Display the adjustment screen
for the superimposed images.
Receiver frame
(green)
Commander frame
(white)
Approx.
ve seconds
The commander's control panel operates
both the commander and the receiver.
Perform projector operations from the
commander's control panel.
The following icon is displayed when
turning the projector system on. The
projector indicated by the arrow is the
subject of any displayed status message.
•
•
Commander
Receiver
Surround the receiver's frame with the commander's
frame.
Adjust the commander's frame (white) so that it is outside the
receiver's frame (green).
Adjust the focus for the commander and receiver.
Superimpose the images.
Size the receiver's frame.
Adjust the receiver's projection size to t the screen.
When suspending
the projectors from
a ceiling, change the
Projection mode before
superimposing the
images. You can change
the Projection mode by
holding down the [A/V
Mute] button on the
remote control for about
ve seconds.
1414141414
Superimposing Images