Place the screws into the holes, and then tighten them securely (on both
the left and right sides). Then tighten the commander's stacking mount
screws as well.
Attach the commander to the receiver by sliding the commander’s
stacking mount screws into the slots in the receiver’s stacking mount.
Then lightly tighten the screws (on both the left and right sides) to secure
the attachment.
4
Secure the stacking mount angle adjustment with screws.
5
Remove the clear
protective lm from the
polarizing lters.
Caution
When attaching the
commander to the
receiver, be careful not to
trap your ngers.
Place marking
stickers on the
positions where the
screws are secured. You
can then use these marks
when reassembling.
99999
There are screw holes
numbered 1 to 4 on
the left and right of the
stacking mount.
You can change the
commander's projection
angle by changing the
position secured by the
screw.
See "Screen Size and
Projection Distance"
on page 18 to determine
which screw hole to use.
To Next Page
Loading...
