174
Note: The Brightness setting does not affect laser brightness. To change the laser brightness mode,
use the Light Source Brightness Control setting in the Operation menu.
Input Source Settings
To change settings for an input source, make sure the source is connected and select that source.
Note: You can restore the default settings of the Tracking, Sync, and Position settings by pressing the
Auto button on the remote control.
Setting Options Description
Source — Displays the current input source
selected
Resolution Auto
Normal
Wide
Sets the input signal resolution if
not detected automatically using
the Auto option (only for
computer inputs)
Aspect See the list of available aspect
ratios
Sets the aspect ratio (width-to-
height ratio)
Analog Signal Adjustment Auto Setup
Tracking
Sync.
Position
Adjusts the signal when
Computer is the currently
selected input source
Auto Setup: set to On to
automatically optimize the image
quality
Tracking: adjusts the signal to
eliminate vertical stripes in
images
Sync: adjusts signal to eliminate
fuzziness or flickering in images
Position: adjusts the image
location on the screen
Reset to Defaults — Resets all settings for the
currently selected input source
Note: Select Reset Image Settings to reset all settings on the Image menu to their default values.
To Next Page
Loading...
