49
8. Select IP Settings and press Enter.
9. Select your IP settings as necessary:
• If your network assigns addresses automatically, turn on the DHCP setting.
• If you must set addresses manually, turn off DHCP and enter the projector's IP Address, Subnet
Mask, and Gateway Address as needed.
Note: To highlight the numbers you want from the displayed keyboard, press the arrow buttons on
the remote control. To select a highlighted number, press Enter. Alternatively, press and hold the
Num button on the remote control while entering the desired numbers.
10. To prevent display of the IP address on the standby screen, turn off IP Address Display in the
Wired LAN menu.
11. Select Return and press Enter to return to the Network Settings menu.
12. Select Network Projection and press Enter.
You see a screen like this:
13. Set the Epson iProjection setting to On.
To Next Page
Loading...
