Epson PRO - Appendix C Commands and Character Tables; Command List

Command List
This printer supports the following ESC/P 2 commands in
your DOS software programs. If you need more information
about using printer commands, you can purchase the ESC/P 2
Reference Manual (ESCP2REF) from EPSON Accessories by
calling (800) 873-7766 (in the U.S. only). In Canada, call
(800) BUY-EPSON for sales locations.
General operation:
ESC @, ESC U 1/0, ESC EM R
Paper feeding
CR, FF, LF, ESC 0, ESC 2, ESC 3 n, ESC + n
Page format
ESC ( c nn, ESC ( C nn, ESC C n, ESC C 0 n, ESC N n, ESC O,
ESC L n, ESC Q n
Print position motion
ESC $ n1 n2, ESC \ n1 n2, ESC ( V nn, ESC ( v nn, ESC D nn,
HT, ESC B nn, VT, ESC J n
Font selection
ESC k n, ESC X nn, ESC P, ESC M, ESC g, ESC p 1/0, ESC x n,
ESC 4, ESC 5, ESC E, ESC F, ESC ! n
Font enhancement
SI, DC2, SO, ESC W 1/0, DC4, ESC w 1/0, ESC G, ESC H,
ESC S 0, ESC S 1, ESC T, ESC ( - nn, ESC - 1/0, ESC q n
Spacing
ESC SP n, ESC ( U nn, ESC c n1 n2
Character handling
ESC ( t nn, ESC t n, ESC R n, ESC & nn, ESC : 0 n 0, ESC % n,
ESC 6, ESC 7, ESC ( ^ nn
Bit image
ESC * nn
Graphics
ESC ( G nn, ESC . nn
Color
ESC r n
MicroWeave
ESC ( i
Select dot size
ESC ( e nn
Binary mode commands for ESC . 2 or ESC . 3
<XFER>, <MOVX>, MOVY>, <COLR>, <CLR>, <EXIT>, <CR>,
<MOVXBYTE>, MOVXDOT>
L
Verde+ Reference Guide
A5 size Appendix C
10-30-95 DR, pass 3-Rev1
C-2 Commands and Character Tables