EPSON Stylus C66
3/04 EPSON Stylus C66 - 7
5. Open the cartridge cover.
6. Pinch the back tab of the empty cartridge as you lift it out of
the printer.
7. Before you remove the new cartridge from its package,
shake it four or five times.
8. Unwrap the new ink cartridge and lower it into the holder.
Push down gently until the cartridge is firmly seated.
Caution
Don’t touch the green circuit board on the front of the
cartridge; you may inhibit normal operation and printing.
9. If you need to replace other ink cartridges, repeat steps 5
through 7 before continuing with step 10.
10. Close the cartridge cover.
11. Close the printer cover and press the H ink button. The
printer begins charging the ink delivery system.
The green P power light flashes and the printer makes
noise. Charging takes about half a minute. When it’s
finished, the green P power light stops flashing and stays
on, and the red H ink light goes out.
Caution:
Never turn off the printer while the P power light is flashing,
unless the printer hasn’t moved or made noise for more than 5
minutes.
Cleaning the Print Head
If your printouts are unexpectedly light, or dots or lines are
missing, you may need to clean the print head. This unclogs
the nozzles so they can deliver ink properly. Print head
cleaning uses ink, so clean it only if quality declines.
This section explains how to clean the print head using the
Head Cleaning utility.
You can also clean the print head by holding down the H ink
button on the printer for three seconds. (This only works
when the red H ink light is off.
Caution:
When you don’t turn on your printer for a long time, print quality
can decline, so turn it on and print a few pages at least once a
month to maintain good print quality.
To Next Page
Loading...
Need help?
Printing
Paper Handling
Dimensions and Weight
