7
6. At the Add Standard TCP/IP Printer Port Wizard, screen click on Next. Then on the next screen type the Type B Ethernet
card’s IP address. Check with your System Administrator for the correct IP address assigned to the Epson Type B Ethernet
card on your network.
7.
If Windows identifies the Epson card automatically, click
Finish
at the
Completing the
Add Standard TCP/IP Printer
Port Wizard. If your card is not identifies as an Epson network card automatically, click on Custom and then Settings. On
the next screen select LPR, type PASSTHRU as the Queue Name, check SNMP Status Enabled and click OK. Click Next
on the
Add Standard TCP/IP Printer Port Wizard
screen to continue with the installation, and then click
Finish on the
next screen. Click Close at the Printer Ports screen.
To Next Page
Loading...
