8
Kauai
short.bk Rev. C
A5 size KAUD.FM
11/5/98 Pass 2
L
Proof Sign-off:
N.Nomoto _______
N.Nomoto _______
K.Norum _______
Attaching the Paper Support
Insert the paper support into the slots at the rear of the printer.
Plugging in the Printer
1. Make sure that the printer is turned off. It is off when the
P
power button protrudes slightly from the surface of the
control panel.
2. Check the label on the back of the printer to make sure the
voltage required by the printer matches that of the electrical
outlet you will be plugging it into. Also, make sure that you
have the correct power cable for your power source.
c
Caution:
It is not possible to change the printer's voltage. If the rated
voltage and your outlet voltage do not match, contact your
dealer for assistance. Do not plug in the power cord.
3. If the power cord is not attached to the printer, connect it to
the AC inlet on the back of the printer.
4. Plug the power cord into a properly grounded electrical
outlet.
To Next Page
Loading...
Need help?
General