13
English
Chapter 2
Copying
Making Copies
See the sections below to make copies.
Loading the Paper
1. Lower the output tray and slide out the extension.
2. Move the feeder guard towards you.
3. While holding down its locking tab, slide the left edge guide
so that the distance between the two edge guides is slightly
wider than the width of your paper.
4. Fan a stack of paper, then tap it on a flat surface to even the
edges.
5. Load the stack of paper in the sheet feeder with the printable
side up and the right edge of the paper resting against the
right edge guide.
Use the line on the feeder guard as an indicator when loading
paper. The right edge of paper is aligned with the line on the
feeder guard.
To Next Page
Loading...
