Epson Stylus CX3700 - Page 103

EPSON Stylus CX3700/CX3800/CX3805/CX3810/DX3800/DX3850 Revision A
DISASSEMBLY/ASSEMBLY Printer Section 103
 When installing the Printhead to the Carriage Unit, match the
guide pins (x2,
) of the Carriage Unit with the positioning
holes (x2) of the Printhead.
 Tighten the s
crews in the order as shown in the figure.
 When i
nstalling the Sub FFC Guide, insert the rib of the Sub
FFC Guide to the notch of the Carriage Unit as shown below.
Figure 4-10. Installing Sub FFC Guide
A D J U S T M E N T
R E Q U I R E D
After removing/replacing the Printhead, perform the adjustment in
the following order. (Refer to Chapter 5 “ADJUSTMENT”)
1. “PG Adju
stment”
2. “Ink Charge” (only after re
placement)
3. “Head ID
Input” (only after replacement)
4. “H
ead Angular Adjustment”
5. “Bi-D Adjustment”
6. “First Dot Adjustment”
Rib