Epson Stylus CX3700 - Page 104

EPSON Stylus CX3700/CX3800/CX3805/CX3810/DX3800/DX3850 Revision A
DISASSEMBLY/ASSEMBLY Printer Section 104
4.4.8 Printer Mechanism
 External view (1)
Figure 4-11. Removing Printer Mechanism (1)
 Part/Unit that s
hould be removed before removing Printer Mechanism
Document Cover / Paper Support Assy. / Scanner Unit / Panel Unit /
Housing Upper
 Removal procedure
1. Rem
ove the screw (x1, ) that secures the Rear Cover, and remove the Rear
Cover.
2. Rem
ove the Eject Ink Joint from the Housing, Lower, grasp the handle of the
Tube Clamp and slide it upwards, and carefully remove the Waste Ink Tube
(of the Ink System Unit side).
3. Release the
Carriage Lock with a flathead screwdriver, and move the Carriage
Unit to the center of the printer.
C.B.P. 3x10 F/Zn
(4±1kgfcm)
Rear Cover
Tabs
Housing, Lower
Carriage Unit
Carriage Lock
Waste Ink Tube Red Line
Tube Clump
Tab
Eject Ink
Joint
C A U T I O N
 The Waste Ink Tube may be broken when it is removed.
If it breaks, replace the Ink System Unit.
 Ink may leak from the Waste Ink Tube. Prepare cleaning rags
beforehand, and be careful not spread ink onto surrounding
area.
C H E C K
P O I N T
When removing the Waste Ink Tube, insert a plastic tweezers or a
similar tool between the rib of the Eject Ink Joint and the Waste
Ink Tube, and pick up the Waste Ink Tube.