Epson Stylus CX3700 - Page 107

EPSON Stylus CX3700/CX3800/CX3805/CX3810/DX3800/DX3850 Revision A
DISASSEMBLY/ASSEMBLY Printer Section 107
4.4.9 PS Board Unit
 External view
Figure 4-14. Removing PS Board Unit
 Part/Unit
that should be removed before removing PS Board Unit
Document Cover / Paper Support Assy. / Scanner Unit / Panel Unit /
Housing Upper / Printer Mechanism
 Removal procedure
1. Peel off
the acetate tapes (x2) that secure the PS Connector Cable.
2. Rem
ove the screw (x1, ) that secures the PS Board Unit, and remove the PS
Board Unit.
Acetate Tapes
C.B.P. 3x10 F/Zn
(4±1kgfcm)
Ferrite Core
and Dent
Rib
PS Board Unit
 Place the Ferrite Core to the dent of the Housing, Lower.
 Route the PS Connector Cable between the ribs of the Housing,
Lower, and secure them with acetate tape.
 When r
outing the PS Connector Cable between the ribs of the
Housing, Lower, pay attention to the following instructions.
• The gap between the PS Connector Cable and the Edge of
the Housing. Lower should be 15 mm.
• The PS Connector Cable should be run off the edge of the
Housing, Lower for 40 ± 2 mm.
• The blue line of the PS Connector Cable should be facing
rear of the Housing, Lower.
Figure 4-15. Routing PS Connector Cable
A D J U S T M E N T
R E Q U I R E D
After replacing/removing the PS Board Unit, perform the following
adjustment. (Refer to Chapter 5 “ADJUSTMENT”)
 “CR Offset”
40±2mm
15mm
PS Connector Cable
Blue Line
Acetate Tape