EPSON Stylus CX3700/CX3800/CX3805/CX3810/DX3800/DX3850 Revision A
DISASSEMBLY/ASSEMBLY Printer Section 117
4.4.15 PE Sensor Board/PE Sensor Lever
External view
Figure 4-27. Removing PE Sensor Board/PE Sensor Lever
Part/Unit
that should be removed before removing PE Sensor Board/
PE Sensor Lever
Document Cover / Paper Support Assy. / Scanner Unit / Panel Unit /
Housing, Upper / Printer Mechanism / ASF Unit / Holder Shaft Unit / Spur Gear
36.8 / Extension Spring 0.143 / Clutch
Removal procedure
1. Rem
ove the shaft of the PE Sensor Lever from the Holder Shaft, and remove
the PE Sensor Lever and Torsion Spring 0.22 in the order as shown in the
figure.
2. Rem
ove Torsion Spring 0.22 from the PE Sensor Lever.
3. Release the PE Sensor Connector Cable from
the groove of the Holder Shaft.
4. Release the tab
(x1, ) that secures the PE Sensor, and remove the PE Sensor
from the Holder SHaft.
Straight Tip
Shaft
Shaft
1
2
Torsion Spring 0.22
L-shaped Tip
PE Sensor Lever
Groove
PE Sensor Connector Cable
PE Sensor
Tab
Fasten the L-shaped tip of Torsion Spring 0.22 to the concave
portion of the PE Sensor Lever, and fasten the straight tip to
the Holder Shaft.
Route the PE Sensor Connector Cable to the groove of the
Holder Shaft so that the Cable does not run off.
To Next Page
Loading...
