Epson Stylus CX3700 - Page 118

EPSON Stylus CX3700/CX3800/CX3805/CX3810/DX3800/DX3850 Revision A
DISASSEMBLY/ASSEMBLY Printer Section 118
4.4.16 CR Guide Frame
 External view
Figure 4-28. Removing CR Guide Frame
 Part/Unit
that should be removed before removing CR Guide Frame
Document Cover / Paper Support Assy. / Scanner Unit / Panel Unit /
Housing, Upper / Printer Mechanism / Main Board Unit
 Removal procedure
1. Release the Head FFCs
(x3) secured with the double-sided tape (x1) from the
CR Guide Frame.
2. Rem
ove the screws (x2, ) that secure the CR Guide Frame, and remove the
CR Guide Frame from the Printer Mechanism.
C.B.S. 3x6 F/Zn (7±1kgfcm)
Guide Pins
2
1
Head FFC
CR Guide Frame
 Match the guide pins (x2, ) of the Front Frame with the
positioning holes (x2) of the CR Guide Frame.
 Tighten the scre
ws in the order as shown in the figure.
 Att
ach the Head FFCs (x3) with double-sided tape to the
position on the CR Guide Frame indicated with printed lines.
Figure 4-29. Attaching Head FFCs
Double-sided
Tape
Printed Lines
(Installation Position)