Epson Stylus CX3700 - 5.2 Adjustment by Using Adjustment Program

EPSON Stylus CX3700/CX3800/CX3805/CX3810/DX3800/DX3850 Revision A
ADJUSTMENT Adjustment by Using Adjustment Program 137
5.2 Adjustment by Using Adjustment Program
The procedures of the adjustment items will be explained here. The intended item is as
follows.
 EEPROM Data
Copy
 Mark
et Setting
 USB ID
Input
 Wast
e Ink Pad Counter
 In
k Charge
 Head ID
Input
 Top Marg
in Adjustment
 Fi
rst Dot Adjustment
 Head Ang
ular Adjustment
 Bi-D Adju
stment
 CR Offset
 PF Band Ad
justment
5.2.1 EEPROM Data Copy
 Adjustment procedure
1. Select “EEPROM Data Copy” in the Adjustment Program.
2. Click the [backup] button to backup the old main board data.
3. When the backup operation is
succeeded,
1) Replace the Main Board Unit with a new one.
2) Turn on the printer and click the [restore] button.
3) When the restore operation is succeeded,
click the [next] button to perform
necessary adjustment.
When the backup operation is
failed,
1) Click the [next] button to perform necess
ary adjustment.
5.2.2 Market Setting
 Adjustment procedure
1. Select “Destination setting” in the Adjustment Program.
Click the [Destination setting] button to set the market destination setting.
5.2.3 USB ID Input
 Adjustment procedure
1. Select “Destination setting” in the Adjustment Program.
Input the 10-digits serial number from the label applied to the back side of the
Ho
using, Lower.
5.2.4 Waste Ink Pad Counter
 Adjustment procedure
1. Select “Waste ink pad counter” in the Adjustment
Program.
2. Click the [Read] button, you can see the current or initialized counter value.
3. If you replace the waste ink pad, click the [Initialize] button
to clear the
current ink pad counter to “zero”. Once you click the [Initialize] button, you
can see its completion message, so that click the [OK] button.