6 Loading Paper
4. Insert the paper, printable side up, against the
right side of the sheet feeder. Always load it short
edge first, even for landscape printing.
Place the stack of paper behind the tabs and make
sure it fits under the c arrow mark inside the left
edge guide.
5. Slide the edge guide against the left edge of the
paper, but not too tightly.
6. Flip the feeder guard back.
Also make sure the paper thickness lever is set
down to the m position.
The printable
side is often
whiter or
brighter than
the other side.
10 × 15 cm (4 × 6 in.)
and 13 × 18 cm
(5 × 7 in.)
The letter L appears
briefly in the Copy
window on the
control panel when
you move the lever
to the m position; the
letter H appears
when you move it to
the ^ position.
To Next Page
Loading...
Need help?
General
