107
■ Align the print head.
■ You may need to increase the image resolution or print it in a smaller size; see
your software documentation.
■ Make sure you’re not printing a PostScript
®
file.
Your printout has a slight slant.
■ Make sure you have loaded the paper correctly. See Loading Paper.
■ Align the print head.
There are scratches on your print.
If you’re printing on glossy paper, prints may be scratched if not handled properly.
Don’t place objects on top of your prints, and be careful not to scratch them with
your fingernails. For best results, frame your prints under glass.
Paper Feeding Problems
Paper doesn’t eject fully or is wrinkled.
■ If the paper doesn’t eject fully, you may have set the wrong paper size. Press the
paper button to eject the paper, and then select the correct paper size.
■ If it’s wrinkled when it ejects, the paper may be damp or too thin. See the Paper
specifications.
Note:
Store any unused paper in its original packaging in a dry area.
Paper doesn’t feed correctly or jams in the printer.
■ Make sure the paper support extension is pulled up.
■ If paper doesn’t feed, remove it from the sheet feeder. Reload it against the right
edge, behind the tabs, then slide the left edge guide against the paper.
■ If multiple pages feed at once, remove the paper from the sheet feeder, fan the
edges to separate the sheets, then reload it.
To Next Page
Loading...
