Epson Stylus Photo 2100 - Page 109

EPSON Stylus PHOTO 2100/2200 Revision B
TROUBLESHOOTING Troubleshooting 109
Ink stain of paper Ink stain occurs at the back or end
of the print paper.
Front paper guide
ink pads
1. Check that heaps of ink are not formed on the Ink pads and that
the Ink pads are installed securely and evenly in the setting
position.
1. If heaps of ink are formed, replace the Ink
pads. At this time, if the ink has solidified in
the Ink pad setting section of the Front paper
guide, it can cause the Ink pads to rise. After
removing the ink, therefore, install new Ink
pads. If it has been confirmed that the Ink pads
have risen, reinstall the Ink pads correctly.
Ink sticks to other than the print
area of the paper, resulting in
contamination.
Paper eject unit 1. Check the Star wheel rollers for ink stain. 1. Clean the Star wheel rollers with a soft cloth.
Front paper guide 1. Check the Front paper guide for ink stain. 1. Clean the Front paper guide with a soft cloth
carefully.
Front paper guide
(Ink pads)
1. Check for the formation of ink heaps. 1. Change the Front paper guide (Ink pads) for a
new one.
Table 3-18. Print Quality Fault Check Points
Print Quality State Phenomenon Detail
Faulty Part/
Part Name
Check Point Remedy
Front paper guide