Epson Stylus Photo 2100 - Removing the PF Roller Support

EPSON Stylus PHOTO 2100/2200 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 181
4.2.17 Removing the PF Roller Support
1. Remove the PF Roller. (Refer to 4.2.15.)
2. Remove the Under Driven Roller.
Figure 4-136. Removing the Under Driven Roller
3. Remove the two screws 6) C.B.S 3×6 (9±1kgf.cm) that secure the PF Roller
Support, and slide the PF Roller Support to the top to remove it from the Upper
Frame.
Figure 4-137. Removing the PF Roller Support
A D J U S T M E N T
R E Q U I R E D
" When removing the Paper Eject Roller Shaft A, the following
adjustments are necessary. Make the adjustments in the
following order.
1. PG adjustment
2. CR tooth skip prevention mechanism adjustment
3. Head cleanig
4. Head angular adjustment
5. Bi-D adjustment
6. Pixel Shift Adjustment
7. PF adjustment
" Refer to "Chapter 5 Adjustment" for the adjustment
procedures.
" After changing the Grounding Spring for a new one, always
apply grease G-26 in the specified position.
Refer to Chapter 6, Figure 6-7, "Lubrication Point 9".
Under Driven
Roller
Hook
Hook
C.B.S 3x6
Hook
C.B.S 3x6
Hook
PF Roller Support
Joggle