EPSON Stylus PHOTO 2100/2200 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 144
4.2.6 Removing the Paper Eject Roller B
1. Remove the Paper Eject Unit. (Refer to 4.2.5.)
2. Return the Carriage Unit to the home position.
3. Release the four hooks, which secure the rear side of the Lower Paper Guide Eject
as seen from the printer front, from the Paper Eject Roller A, and turn it toward the
front.
4. Release the five hooks, which secure the front side of the Lower Paper Guide Eject
as seen from the printer front, from the Paper Eject Roller B, and remove the
Lower Paper Guide Eject.
Figure 4-52. Removing the Lower Paper Guide Eject
5. Remove the C Ring of the Spur Gear 62 mounted on the left end of the Paper Eject
Roller B, as seen from the printer front, from the Paper Eject Roller B, and then
remove the Spur Gear 62.
Figure 4-53. Removing the Spur Gear 62
When reinstalling the Lower Paper Guide Eject, match the convex
portion on the rear center side, as seen from the printer front, with
the notch of the specified hook on the right center side of the Front
Paper Guide.
Refer to Figure 4-52, "Removing the Lower Paper Guide Eject".
Paper Eject Roller B
Rear hooks
Paper Eject Roller A
Convex
portion
Front hooks
Front hooks
C A U T I O N
" When removing the C Ring, fully take care not to lose it.
Refer to Figure 4-53, "Removing the Spur Gear 62".
" Since the Spur Gear 62 is a precision gear, change it for a new
one once it has been removed.
Refer to Figure 4-53, "Removing the Spur Gear 62".
" When reinstalling the Spur Gear 62 to the Paper Eject Roller B,
hold the center of the Spur Gear 62 and carefully mount it to the
Paper Eject Roller B. If you hold the periphery of the Spur Gear
62 when mounting, it will deform and the paper loading accuracy
will reduce.
Refer to Figure 4-53, "Removing the Spur Gear 62".
" When reinstalling the Spur Gear 62, it is recommended to press-
fit the Spur Gear 62 into the Paper Eject Roller B using a
mounting plate scale jig.
Spur Gear 62
C Ring
To Next Page
Loading...
