Epson Stylus Photo 2100 - Removing the PF Roller

EPSON Stylus PHOTO 2100/2200 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 175
4.2.15 Removing the PF Roller
1. Remove the Paper Eject Roller Shaft B. (Refer to 4.2.6.)
2. Remove the Carriage Unit. (Refer to 4.2.9.)
3. Release the three hooks, which secure the front side of the Front Paper Guide as
seen from the printer front, from the Paper Eject Roller Shaft A, and while lightly
pulling the Front Paper Guide to the front, turn it upward to release the rear left
side hook of the Front Paper Guide, and remove the Front Paper Guide.
Figure 4-123. Removing the Front Paper Guide
4. Release the three hooks, which secure the Rear Paper Guide as seen from the
printer rear, from the Under Frame, release the two hooks that engages with the PF
Roller, and remove the Rear Paper Guide.
Figure 4-125. Removing the Rear Paper Guide
C A U T I O N
Fully be careful when removing the Front Paper Guide, since the
paper loading accuracy will reduce if the coating on the PF Roller
surface peels off. This also applies to reinstallation.
Refer to Figure 4-123, "Removing the Front Paper Guide".
Front Paper Guide
Hook
Hooks
PF Roller
Bring the Grounding Plate, which is located on the bottom right
side of the Front Paper Guide as seen from the printer front, into
contact with the Frame in advance.
Refer to Figure 4-124, "Position of the Grounding Plate".
Figure 4-124. Position of the Grounding Plate
Grounding Plate
Hooks
Rear Paper Guide
Hooks
PF Roller