Epson Stylus Photo 2100 - Page 124

EPSON Stylus PHOTO 2100/2200 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 124
4.2.1.3 Removing the Middle Housing
1. Remove the Upper Housing. (Refer to 4.2.1.1.)
2. Remove the two screws 3) C.B.P 3
×14 (6±1kgf.cm), which secure the Middle
Housing, from the Middle Housing.
Figure 4-9. Screws That Secure the Middle Housing
3. Release the six hooks, which secure the left and right of the Middle Housing, from
the Lower Housing, and while turning the Middle Housing rearward as viewed
from the printer front, lift it to remove.
By pushing the cutouts of the Lower Housing toward the printer inside one by one
to disengage them from the hooks of the Middle Housing, you can release the
hooks easily.
Figure 4-10. Hooks That Secure the Left and Right of the Middle Housing
An easy way to reinstall the Rear Housing is to insert the upper
hooks of the Rear Housing into the Middle Housing, mount the
Rear Housing using the two upper hooks as supports, and fit the
cutouts of the Rear Housing into the lower hooks of the Lower
Housing.
Refer to Figure 4-8, "Hooks and Cutouts That Secure the Rear
Housing".
Front left
side
Front right side
C.B.P 3×14
C.B.P 3×14
Middle Housing
Hooks
Hooks