Epson Stylus Photo 2100 - Page 13

EPSON Stylus PHOTO 2100/2200 Revision B
PRODUCTION DESCRIPTION Basic Specifications 13
Sensors
CR encoder Linear scale + encoder sensor
PF encoder Loop scale + encoder sensor
PE detector Transparent photo interrupter
PE detector (rear) - - -
PG detector Mechanical contact (2 pcs.) -
Paper leading edge/
paper width detector (PW sensor)
Transparent photo interrupter -
I/C detector CSIC
ASF HP detector Clutch detection Transparent photo interrupter
CDR tray detector Also used as PF sensor Mechanical contact -
Cutter CR position detector Transparent photo interrupter
Transparent photo interrupter
(2 pcs.)
-
Main board
Control code
ESCP/2
ESCP remote
Interface
Panel (IEEE1284.4 compatibility)
USB USB (2.0 compatibility) USB
- IEEE1394 (400Mbps) -
USB (transfer speed) 12Mbps 12Mbps to 480Mbps 12Mbps
Main board C456Main−B C387Main C304Main/C298Main−B
Input buffer 256KB 112KB 256KB
PROM application Program Program & 2 Tables (PC437, PC850) Program & 2 Tables (PC437, PC850)
PROM type SOJ SOJ, 8Mbit, 3.3V DIC, 8M, 3.3V
Backup battery Installed Installed Installed
Backup battery type Capacitor Capacitor Lithium battery
Backup battery life
1 week
(electricity accumulated every power-on)
1 week
(electricity accumulated every power-on)
5 years
Power board
Power board C456PSB/PSE C387PSB/PSE C298PSB/PSE
Power switch Push switch with locking function
Output voltage 42V/5V
Panel board Panel board C456PNL C387PNL C304PNL
Table 1-1. Specification Outline Comparison
Item Stylus PHOTO 950 Stylus PHOTO 2100/2200 Stylus PHOTO 2000P