EPSON Stylus PHOTO 2100/2200 Revision B
TROUBLESHOOTING Error Indications and Fault Occurrence Causes 72
Paper Jam Error - Blink - This error is detected when the paper remaining near the
PE sensor cannot be ejected in the paper loading
sequence, or if the paper near the PE sensor cannot be
ejected with the FF command or Paper switch.
Paper Gap Error - On - This error is detected if the printer judges that the
Carriage made contact with the paper, which was fed
from the Paper guide manual (Board paper feeding port),
at the time of paper width detection.
"-" : don't care High speed Blink : 0.1sec on + 0.1sec off repetition
Blink : 0.5sec on + 0.5sec off repetition Blink alternately 1 : 0.5sec on + 0.5sec off repetition
Blink 2 : 0.2sec on + 0.2sec on + 0.2sec on 0.4sec off repetition Blink alternately 2 : 0.5sec on + 0.5sec on repetition
Table 3-1. Error Indications and Fault Occurrence Causes
Printer Condition
Indicators
EPSON Printer Window 3 Fault Occurrence Cause
Power Paper Ink 1-7
To Next Page
Loading...
