Epson Stylus Photo PX800FW - Page 29

Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W
Revision C
PRODUCT DESCRIPTION
Interface
https://www.manualsbooks.com
24
Confidential
Table 1-17. Combination of the Wired LAN communication mode settings
Setting of this printer
Setting of the connected device
Auto Setting
Auto Setting (AUTO)
100BASE-TX Half Duplex
10BASE-T Half Duplex
100BASE-TX Full Duplex
100BASE-TX Full Duplex
100BASE-TX Half Duplex
Auto Setting (AUTO)
100BASE-TX Half Duplex
10BASE-T Full Duplex
10BASE-T Full Duplex
10BASE-T Half Duplex
Auto Setting (AUTO)
10BASE-T Half Duplex
 Wireless LAN
The following interface is equipped for the Wireless LAN connection.
Table 1-18. Wireless LAN
Item
Content
Applied Standard
(2.4GHz spectrum band
wireless network
standards)
Conforms to IEEE802.11b, IEEE802.11g
Wireless Operation Mode
IEEE802.11b
DS-SS (Half Duplex)
IEEE802.11g
OFDM (Half Duplex)
Communication Range
(line-of-sight distance)*
IEEE802.11b (11Mbps)
• 60m (indoor)
• 220m (outdoor)
IEEE802.11g (54Mbps)
• 20m (indoor)
• 100m (outdoor)
Communication Mode
Ad-hoc (IBSS) or Infrastructure (ESS)
Roaming Function
Not supported
Output Signal Intensity
10mW
Antenna
Built-in antenna (Diversity function is not supported)
Note * : Referential value. It depends on surrounding conditions.
Table 1-19. Available Channels and Standard
Frequency Band
(GHz)
Channel
IEEE Standard
Communication Speed
(bps)*
2.400 - 2.4835
1 - 13
802.11b
11/5.5/2/1M
2.400 - 2.4835
1 - 13
802.11g
54/48/36/24/18/ 12/9/6M
2.471 - 2.497
14
802.11/11b
11/ 5.5/2/1M
Note "*": The communication speed will be changed automatically, depending on radio wave
strength. bps = bit per second.
Switching Wired/Wireless LAN
This printer can be connect to the network via either Wired LAN or Wireless LAN
connection only.
Enabling/disabling the Wireless LAN can be made from the Control Panel. When the
Wireless LAN is enabled, it gets priority over the Wired Lan regardless of whether the
LAN Cable is connected. The default Wireless LAN setting is “ Disabled” .
Table 1-20. Wireless LAN Setting from the Control Panel
Setting from Control Panel
LAN Cable Connection State
Connected
Disconnected
Wireless LAN
Disabled
(Default)
Wired LAN
---*
Enabled
Wireless LAN
Wireless LAN
Note* : No service via network is available without connecting the LAN Cable (because
network communication is not established.) except printing a status sheet or the like.
�
�
�
�
�
� �
�
� �
When changing the networks while the power is on, wait at least for
10 seconds between disconnecting and reconnecting.