4 Insert the cartridges in the holder for each color.
5 Press the cartridges down until they click.
6 Close the cartridge cover, then close the printer cover.
7 Press the ink button to begin priming the ink delivery system. This
takes about 4 minutes. Do not turn off the printer, load paper, or open
any covers until the process is complete.
Caution: Don’t turn off the printer while it is priming or you’ll
waste ink.
Unpack
Caution: Do not open ink cartridge packages until you are ready to install
the ink. Cartridges are vacuum packed to maintain reliability.
1 Remove all protective materials.
2 Open the top cover and remove any tape inside.
1
Turn on
1 Connect the power cable.
Caution: Do not connect to your computer yet.
2 Press the power button.
Install ink cartridges
1 Open the printer cover, then open the ink cartridge cover.
2 Shake the ink cartridges gently 4 or 5 times, then unpack them.
3 Remove only the yellow tape from each cartridge.
Caution: Don’t remove any
other seals or the cartridges
may leak.
2
*412146800*
*412146800*
3
3 Load paper against the right edge and behind the tab. Then squeeze
the edge guide and slide it to the edge of the paper.
Note: Don’t load the paper sideways. Always load
it short edge fi rst.
Rear manual feed slot
You can print on these paper types using the single
sheet guide and the rear manual feed slot:
• Epson Hot Press Bright
• Epson Hot Press Natural
• Epson Cold Press Bright
• Epson Cold Press Natural
• Epson Velvet Fine Art Paper
• Epson Matte Scrapbook Photo Paper
1 Remove any paper from the sheet feeder and close the paper
support.
2 Make sure the output tray is open and the extensions are pulled out.
3 Slide the roll paper edge guide on the back of the printer all the way
to the right
4 Attach the single sheet guide by aligning the notches on its base with
the slots on the back of the printer. Then hook the tabs over the top of
the slot (marked with orange triangles).
4121468 Rev.0
1-F C
4121468 Rev.0
1-F M
4121468 Rev.0
1-F Y
4121468 Rev.0
1-F K
Start Here
Epson Stylus
®
Photo R2000 Series
Read these instructions before using your product.
4
Load paper
Sheet feeder
You can load plain paper, and most glossy and matte papers, in the
sheet feeder.
1 Open the paper support and pull up the extensions.
2 Open the output tray and pull out the extensions.
To Next Page
Need help?
General
