19
Loading a Filmstrip
1 Lift off the filmstrip cover.
2 Slide the strip of film into the film holder, with the duller
(emulsion) side up (the images should appear reversed). Position
the top of the images next to the outside edge of the film holder.
3 Reinstall the filmstrip cover over the strip of film (it snaps into
place). Press it around the edges to make sure it is closed.
4 Place the film holder on the glass, inserting its positioning posts
into the two holes near the scanner lid.
Make sure the film
is toward the center
of the glass
Holes
To Next Page
Loading...
