Scanning Film or Slides 41
4. Press the
Scan button to set the RX620 to Scan mode.
5. Use the u and d buttons to choose
Scan to Memory Card, then press the
OK button.
6. Use the u, d, l, and r buttons to select the following options:
■ Scan area: select Auto cropping (if the edges of the photo are light in
color, select
Max area)
■ Document type: select Graphics
■ Quality: select Photo
7. Press the x Color button. The photo is scanned and saved to the “epscan”
folder on your memory card.
8. When scanning is finished, you see a confirmation screen. Note the name
given to your image and its location on the card.
9. Click
OK when done, then remove the card.
Caution:
Do not remove the card or turn off the Stylus Photo RX620 while the memory card light
is flashing, or you may lose data.
Scanning Film or Slides
After inserting a memory card (see page 39), you can scan film or slides to the card
and save your photos in JPEG format. Follow the steps in these sections:
■ “Removing the Film Holder and Document Mat” on page 42
■ “Placing 35-mm Slides in the Holder” on page 43
■ “Placing 35-mm Film Strips in the Holder” on page 44
■ “Scanning and Saving to Your Memory Card” on page 45
To Next Page
Loading...
