2
Checking the Package Contents
Make sure that all the items shown below are
included and not damaged. Remove all protective
materials packed with this unit before you set it
up and turn on the power. Save all packaging and
protective materials in case you need to transport
the printer later.
Installing the Auto Take-Up Reel
Unit
c
Caution:
Use only the provided screws when installing
the auto take-up reel unit. Use of non-issue
screws can leave components insecurely
fastened, increasing the risk of injury and
printer damage.
Before starting:
❏ Make sure that the printer is turned off.
❏ Remove the paper basket or push the front
part of the paper basket to the rear to keep it
out of the way.
Drive unit (with control box) Movable unit
Take-up reel core (3 inch)
Sensor unit Screws (Large 2, small 4)
Cable clamps Drafting tape
Movable unit stopper Cable connector
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
