4
Installing the sensor unit
The sensor components are shown below.
1. Set the sensor unit’s light emitter in the bottom
of the drive unit, and then secure it with a
screw.
2. Set the sensor unit’s light detector in the base
unit’s bottom left side, and then secure it with
a screw.
3. Plug the connector of the sensor unit cable into
the socket located at the top rear of the control
box on the drive unit.
4. Fasten the cable using the cable clamps
provided. Use as many of the clamps as
necessary to secure the cable.You may need to
do this from the back of the printer.
Light detector
Connector
Light emitter
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
