6
3. Remove the flange.
4. Reverse the flange so that the smaller knob is
positioned on the outside, then replace it on
the drive unit.
5. Replace the cap and fastener, which you
removed in step 2, on the drive unit.
6. Remove the fastener from the movable unit.
Next, remove the flange.
7. Reverse the flange so that the smaller knob is
positioned on the outside, then replace it on
the movable unit.
8. Replace the fastener, which you removed in
step 6, back on the movable unit.
9. Install the 2-inch take-up reel core in the auto
take-up reel unit in the same manner as
described in “Installing the 3-inch take-up reel
core” on page 5.
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
