R
3
R41A0E84P
Unpacking and Setup Guide
Rev.D
ENGLISH.FM A4 size
6/19/07
Proof Sign-off:
AVA M.Arai K.Nishi
K.Nishi
Latex H.Nicholas
English
Unpacking and Assembling the
Base Unit
Checking the contents
1. Open the box, and then lift up the box that
contains the base unit and away from the
printer.
2. Open the box that contains the base unit, and
make sure that all the items shown below are
included and not damaged.
Assembling the base unit
w
Warning:
Have two people working on either side to
assemble the base unit (23.2 kg).
1. Hold base upright left and a horizontal strut
as shown. Then fix the strut to the base using
the two hex socket head bolts with the hex
wrench.
Note:
Do not fasten the screws too tight. Leave room to
adjust the position when you fasten the screws on
the other base upright.
2. Referring to step 1, secure the other side of the
strut to the base.
3. Fasten four screws on the both sides of the
base upright securely.
This completes assembly of the base unit. Then,
see the next section for unpacking the printer.
Base upright, left / Base upright, right
Horizontal strut
Hex wrench Hex socket head bolts (4)
Wing nuts, spring washers, and washers (4)
To Next Page
Loading...
