Loading Roll Paper
Loading Roll Paper
1
Slide the black paper stop off the end of
the spindle.
Note: To use paper with a 2-inch core, remove the
gray adapters from the paper stops at each end.
See your Printer Guide for details.
2
Position the roll as shown, then slide it onto
the spindle.
3
Slide the black paper stop back onto the spindle
and insert it firmly into the end of the roll.
7
Release the paper lever.
8
Hold both sides of the paper and feed it into
the slot.
9
Make sure the paper is aligned with the OTHER
mark and the vertical line next to the arrow. Then
return the paper lever to the secured position.
4
Open the roll paper cover.
5
Place the roll paper in the printer as shown. (The
gray end of the spindle goes on the right.)
6
Make sure the printer is turned on, then press the
Paper Source button until the or icon
appears.
Caution: To avoid feeding excess paper, make sure
you don’t select
when you’re using roll paper..
10
Raise the roll paper support on top of the
paper tray. Then close the roll paper cover.
Caution: To prevent creasing the paper, remove it
from the paper path and roll it up when you’re not
printing.
1
OTHER mark
Vertical line
To Next Page
Need help?
General