Epson Stylus Pro 7710 - Page 208

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 208
Confidential
4.4.2.6 Maintenance Tank (L/R)
1. Pull the handle of the Maintenance Tank R and remove the Maintenance Tank R.
NOTE: Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/WT7900/
WT7910/7890/7908 does not have the Maintenance Tank L.
Figure 4-20. Removing the Maintenance Tank (L/R)
C H E C K
P O I N T
Basically you can remove this part on the left and the one on the
right in the same way. Therefore this section describes the way to
remove the one on the right only.
C A U T I O N
Make sure to use the Maintenance Tank with the type specified
below.
 Epson Stylus Pro 7900/7910/9900/9910/9890/9908/7890/7908:
C12C890191 / C12C890193
 Epson Stylus Pro 7700/7710/7700M/7710M/9700/9710:
C12C890501 / C12C890502
 Epson Stylus Pro WT7900/WT7910:
C12C890191 / C12C890193
Maintenance Tank R