Epson Stylus Pro 7710 - Page 279

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 279
Confidential
8. Release the Ink Tubes from the two hooks on the Ink Cartridge Holder R.
9. Pull the Ink Tube backward to give it some slack.
10. Release the Ink Tubes from the six hooks on the Ink Tube Guide.
Figure 4-126. Releasing the Ink Tube Guide (before released)
Figure 4-127. Releasing the Ink Tube Guide (after released)
Pull the Ink Tube forward to remove the slack. Route the Ink Tube
so as not to apply load to the bend of the tube at the front of the
printer.
C A U T I O N
Be careful not to apply load to the joint of the Ink Cartridge Holder
R and the Ink Tube.
- Rear right -
Ink Tube Guide
Hook
- Rear right -