Epson Stylus SX405 - Bi-D Adjustment; PF Adjustment

EPSON Stylus CX7300/CX7400/DX7400/NX200/TX200 series/SX200 series/Stylus CX8300/CX8400/DX8400/NX400/TX400 series/SX400 series Revision C
ADJUSTMENT Using the Adjustment Program 148
Confidential
5.2.4 Bi-D Adjustment
The following pattern is printed for each of the five print mode (five dot size modes).
Figure 5-5. Bi-D Adjustment Printout Pattern
How to Judge
Examine the printout patterns for each of the five modes, and enter the value for the
pattern with no gap and overlap for each mode.
Additional Information
If no OK pattern is printed, enter the value for the best one, and print the adjustment
pattern again.
5.2.5 PF Adjustment
 PF- for standard print area
The following pattern is printed.
Figure 5-6. PF (standard print area) Adjustment Printout Pattern
How to Judge
1. Examine the printed patches from the left to the right, and select a value for
the patch with least white oblique lines on its upper (top) area. If two or more
patches are found as the best patch, be sure to select a value for the left most
one.
Figure 5-7. PF Adjustment (1)
2. Examine the printed patches from the right to the left, and select a value for
the patch with least white lines on its lower (bottom) area. If two or more
patches are found as the best patch, be sure to select a value for the right most
one. If it is difficult to judge, compare the most likely patch with the one on
the left.
Figure 5-8. PF Adjustment (2)
C H E C K
P O I N T
Example for judgement
11
12
13
14
15
10
9
OK NGNG
Gap
Overlap
1 2 3 4
Top
Bottom
6
23 4 5
1
Select this Do not select this
6
23 4 51
5
Do not select this Select this