Start Here
3 Squeeze the edge guide and slide it to the left.
4 Load paper against the right edge guide and behind the
tab, with the printable side face up.
4 x 6 in.
(10 x 15 cm)
8½ x 11 in.
or A4
Note: Don’t load the paper sideways; always load it short
edge first.
5 Slide the edge guide over, against the left edge of
the paper.
Read these instructions before using your printer.
1
Unpack
Power cord
USB Cable
Output tray
Caution: Do not open the ink cartridge package until you are ready to
install the ink. Cartridges are vacuum packed to maintain reliability.
Remove all protective materials.
2
Turn on
1 Connect the power cable.
Caution: Do not connect to your computer yet.
2 Press the power button.
3
Install ink cartridges
Caution: keep ink cartridges out of the reach of children and don’t drink
the ink.
Note: The ink cartridges included with your product have a lower yield
due to the ink charging process. This process is carried out the first time
the product is turned on and guarantees a better performance.
Do not load paper yet.
1 Open the printer cover.
Caution: Do not touch the white cable inside the printer.
2 Shake the ink cartridges, then unpack them.
3 Remove only the yellow tape from each cartridge.
Caution: Don’t remove any other seals from the cartridges.
4 Insert the cartridges in the holder for each color, and press
each cartridge down until it clicks.
5 Close the printer cover.
6 Press the stop button to charge the ink. Charging takes
about 2 minutes.
Caution: Don’t turn off the printer while it is charging or you’ll
waste ink.
4
Load paper
1 Open the paper support, then pull up the extension and tilt
it back slightly.
2 Insert the output tray.
Epson Stylus
®
T22
To Next Page
Need help?
General
