Epson Stylus TX105 - Page 78

Epson Stylus NX100/105/SX100/105/TX100/101/102/103/105/106/109/ME 300/ME OFFICE 360/NX110/115/SX110/115/TX110/111/112/113/115/117/119 Revision C
DISASSEMBLY/ASSEMBLY Disassembling the Printer Mechanism 78
Confidential
7. Remove the Head FFC from the connector of the Printhead, and remove the
Printhead.
Figure 4-33. Removing the Printhead (7)
 When installing the FFC, route it through objects as shown in
Fig.4-28 and Fig.4-32.
 When installing the FFC Cover, insert its rib to the hole of the
CR Unit and secure it with the hook. (
See Fig.4-31.)
Printhead
Head FFC
 When installing the Contact Assys, secure them to the Holder
Contact Assy with two each hooks on the Contact Assys.
Figure 4-34. Assembling the Holder Contact Assy (1)
 When installing the CR Contact Module, secure it with four
hooks of the Holder Contact Assy.
Figure 4-35. Assembling the Holder Contact Assy (2)
A D J U S T M E N T
R E Q U I R E D
Whenever the Printhead is removed/replaced, the required
adjustments must be carried out.
• Chapter 5 “ ADJUSTMENT” (p.110)
Front
Contact Assys
Hook
Back
CR Contact Module
Holder Contact Assy
Hook