Confidential
Revision Status
Revision Date of Issue Description
A April 22, 2011 First Release
B June 22, 2011 Revised Contents
Preface
" Safety Precautions (p3)" has been added.
Chapter 1
Made change in "1.1.1 Troubleshooting Workflow (p10)".
Made change in "1.3.1 Displaying the Fatal Error Code (p14)".
Made change in "1.3.2 Printer Fatal Error Code (p15)".
Made change in "1.3.3 Scanner Fatal Error Code (p18)".
Chapter 2
Made change in "2.1.3 Locations of the Parts/Units (p21)".
Made change in "2.1.4 Standard Operation Time for Servicing the Product (p24)".
Made change in "2.2.1 Disassembly Flowchart (p27)".
Caution in " Housing Left/Housing Right (p32)" has been added.
Made change in " PS Unit (p32)".
Made change in " Waste Ink Pad Assy (p32)".
Made change in " Panel Housing Lower Assy (SX235W series) (p33)".
" Panel Housing Lower Assy (SX440W series) (p33)" has been added.
" Panel Board w/Touch Panel (SX440W series) (p34)" has been added.
Made change in " Main Board (p34)".
Made change in " LD Roller Assy (1) (p34)".
" Paper Guide Front Porous Pad (p35)" has been added.
Made change in " Paper Guide Lower Porous Pad (p35)".
Made change in " PF Driven Pulley Assy / PF Timing Belt (p35)".
Made change in " Main Frame Assy (p36)".
" PF Grounding Spring (p37)" has been added.
" Wireless LAN Module (SX235W series/SX430W series/SX440W series) (p37)" has
been added.
Made change in " Main Board (p38)".
Made change in " Panel Unit (1) (p38)".
Made change in " Panel Unit (2) (p38)".
Made change in " Inside the Panel Unit (SX230 series/SX235W series/SX430W series)
(p38)".
" Inside the Panel Unit (SX440W series only) (p38)" has been added.
Made change in " Card Slot Board (SX230 series/SX430W series/SX440W series)
(p39)".
Made change in " Head FFC (2) (p39)".
Made change in " PS Unit (p40)".
Made change in " PF Motor (p40)".
Made change in " Scanner FFC (p40)".
Made change in " PF Encoder Sensor (p40)".
Chapter 3
Made change in "3.1 Required Adjustments (p42)".
Made change in "3.2.3 Scanner Motor Heat Protection Control (p48)".
Made change in "3.3.1 Checking the Platen Gap (p49)".
"3.3.2 CR/PF Belt Tension Check (p50)" has been added.
To Next Page
Loading...
Need help?
General