10 TM-J7000/J7100 User’s Manual
English
When the POWER LED quits flashing and stays on, the printer is
ready for printing.
Disposal of Used Cartridges
Dispose of used ink cartridges as industrial waste products. Obey
the laws and regulations of your country and district.
Ink Cartridge Life
To make your ink cartridges last as long as possible, follow these
simple rules:
❏
Don’t turn off the power supply switch immediately after
printing is completed.
❏
Don’t remove an ink cartridge unless you are replacing the
cartridge.
❏
Don’t turn the printer on and off unnecessarily.
❏
Don’t press the CLEANING button unless the print is faint or
uneven.
Troubleshooting
ERROR LED is flashing or lit
❏
The print head temperature may be high or low. Wait until the
print head cools or warms and the printer resumes printing
automatically.
❏
Make sure that the roll paper cover is properly closed.
❏
If a paper jam has occurred, open the roll paper cover or the ink
cartridge cover and remove the jammed paper. Do not pull the
jammed paper by force or use tools. Be sure to remove it
manually.
❏
Turn off the power, wait several seconds, and then turn it on
again. If the error remains, contact your supervisor or a
qualified service person.
Cleaning
If printing becomes faint or uneven and the INK OUT LED is not on
or flashing, press the CLEANING button until the printer
mechanism begins to clean the print head (more than 3 seconds).
The POWER LED flashes during cleaning. When the cleaning stops,
the printer is ready for normal printing.
To Next Page
Loading...
