Epson TM-J7100 - Memory Switch MSW1 Details; Memory Switch MSW2 Details

Rev. A Adjustments and Settings 2-5
TM-J7000/TM-J7100 Developer’s Guide
Confidential
Memory Switch Msw 1
NOTE:Msw 1-7 and 1-8 are effective only when the serial interface is used.
Msw 2 is defined as follows:
Memory Switch Msw 2
Msw 8 is defined as follows:
Memory Switch Msw 8
Bit Function 0 (Off) 1 (On)
1
Transmits the power ON
information
Does not transmit Transmits
2Reserved -- --
3 Conditions for BUSY
Receive buffer-full or
offline
Receive buffer-full
4
Data processing for receiving
error
Prints "?" Ignored
5 Automatic line feed Disabled Enabled
6 Connection of DM-D Not connected Connected
7 Pin #6: Selection of reset signal Not used Used
8 Pin #25: Selection of reset signal Not used Used
Bit Function 0 (Off) 1 (On)
1
Reserved (the setting must not
be changed)
-- Fixed to On.
2 Autocutter operation Disabled Enabled
3Reserved -- --
4Reserved -- --
5Reserved -- --
6Reserved -- --
7Reserved -- --
8Reserved -- --
Bit Function 0 (Off) 1 (On)
1Reserved -- --
2Reserved -- --
3Reserved -- --
4Reserved -- --
5Reserved -- --