Epson WF-C8690 Series - Operation Check

1. Peel o the seal for the service port (a) on the back of the MFD.
2. Connect the USB cable for the authentication device to the MFD.
3. Place the authentication device on the authentication device table, and secure it with double-sided tape if
necessary.
Operation check
e
following procedures explain how to check the connection status and authentication card recognition for the
authentication device.
❏ MFD’s control panel
Information is displayed if you select Settings > Authentication Device Status.
❏ Web
Cong
Status is displayed in Status > Product Status > Card Reader Status.
❏ Conguration Status Sheet
Status is displayed in Hardware Conguration > Hardware > Card Reader Status.
Hardware Setup Guide
3. Authentication Device
14