Epson XP-434 - Enabling Wi-Fi Direct Mode

40
Peer-to-peer mode
The product communicates one-to-one with another Wi-Fi Direct capable device. When operating in
this mode, your product displays a Direct or D connection symbol on the LCD screen.
To disconnect a peer-to-peer mode connection, release the connection to your product from your
computer or other device.
To enable peer-to-peer mode, you must select it from the Web Config Utility, under WiFi/Network
Settings > Services > Wi-Fi Direct.
Enabling Wi-Fi Direct Mode
Parent topic: Wi-Fi Networking
Enabling Wi-Fi Direct Mode
You can enable Wi-Fi Direct mode to allow direct communication between your product and computer or
other devices without a wireless router or access point.
1. Press the home button, if necessary.
2. Press the left or right arrow button to select Wi-Fi Setup and press the OK button.
You see this screen:
3. Press the up or down arrow button to select Wi-Fi Direct Setup and press the OK button.
4. Make sure Connection Setup is highlighted, then press the OK button.