EN
85
•
Make sure the dimension of opening for the appliance is 595mm long and
435mm high.
•
Make sure the distance between the appliance and the wall is more than 100mm.
• Make sure the distance between the appliance and two sides, top of the mantel
is more than 100mm.
• Plug in the appliance and push the appliance slowly into the mantel.
• Fix the fireplace with the fixing bracket and screw.
INSTRUCTIONS FOR USE
INSTRUCTIONS FOR INSTALLATION
MANUAL OPERATION
The appliance can be operated either by the switches located at the front right
hand side above the fire or by the supplied remote control.
Temperature and serial number display: Normally it displays the room
temperature; while setting the temperature, the setting temperature is displayed;
When setting the timer, serial number is displayed.
Time/ Temperature display: Normally it displays the current time; while setting
the timer, the setting time is displayed. When setting the temperature of the
week timer, the setting temperature is displayed.
Time on and time off: It is displayed while setting the timer, and it is used in
combination with serial number setting.
Flame brightness: It displays the current brightness of the flame, which ranges
from one to five positions.
• The switches located at the front right hand side above the fire. The standby
switch must be first switch on.
• Press once the “F” button to turn on the appliance and flame effect. A red
indicator light will appear to indicate that the function is ON. Press the “F” button
for 3 seconds this will operate the dimmer mode.
• Press the 1000W button once for the low heat settings; press twice to switch off
the heat setting.
To Next Page
Loading...
