EQUATION EF461L-E - Remote Operation; Remote Control Boot Steps; Open Window Detection Feature

EN
86
• Press the 2000W button once for the high heat settings; press twice to switch off
the heat setting.
REMOTE OPERATION
• The standby switch located at the front right hand side above the fire must be
first switch on.
• It takes some time for the receiver to respond to the transmitter. Do not PRESS
the buttons more than once within two seconds for correct operation.
1. Boot steps
1) Connect the power
2) Turn on the power switch
3)Press the “
“ key of the remote controller to start up
4) Press the 1000W button for the 1000W heat settings; press twice to switch
off the heat setting.
5) Press the 2000W button for the 2000W heat settings; press twice to switch
off the heat setting.
6) Press the DIMMER button for operate the dimmer mode.
2. Room temperature control system with open window detection
1) Press the button “
”or “F” on the fireplace, the heater will come into in the
working situation, open the heating function for some time.
2) Press the button “
” on the remote control, the LED display will show “
”.
3) When the fireplace heater detect the room temperature down suddenly, for
example, the window of the room is open, then the fireplace heater stop the
heating function, then the LED display showing of “
” will blink.
4) The heating function cannot operate during one hour by itself, but you can
press the button “
” again, exit the open window detection function.