EN
87
3. Setting the day and time
1) Settings are done on the remote controller
2) Press “DATE TIME” button, then press the “▲” or “▼” key to select the day
3) Press “DATE TIME” button again, then press the “+” or “-” to set the hour
4)Press “DATE TIME” button again, then press the “+” or “-” to set the minute
5) Press “OK” button to complete
4. Temperature setting
The default set temperature is 20 °C, press “+” or “-” on the remote controller
to set the temperature, which ranges from 15 to 30 °C. And this setting is only
for the temperature in the normally mode, not for the temperature in the timer
mode.
5. Timer setting
1) Description of timer setting
There are up to 9 items for timer setting
Each setting item has its date, power-on time and shutdown time
The max. duration of each setting item is 23 hours 50 minutes
The setting date for each item can be any day or days of a week
The date in each setting item represents the date of power-on time
If the shutdown time of the setting falls on the second day, it is unnecessary to
set the date – you just set the shutdown time
2)Steps to view the timer setting
Press the “PROG SET” button
Press the “+” or “-” to check the power-on time of the timer one by one.
For checking the shutdown time, press the “▲” button
Press the “+” or “-” to continue viewing
For deleting the current item of setting, press “C” to delete
3) Steps for timer setting
(I) Select the settings of the serial number
Press the “PROG SET” button, and the serial number starts blinking
Press the “+” or “-” to change the serial number until you get the serial number
that you need to set or modify.
To Next Page
Loading...
