EN
88
(II) Select date
Press “ PROG SET” button once again, and the cursor on the left side of day starts
blinking
Press the “▲” or “▼” keys to move the cursor to the corresponding day, press
the “+” to add the corresponding day, or press “-” to delete the day until you have
completed the selection of all dates
(III) Set the start time
Continue to press the “ PROG SET” button, the hour starts blinking
Press the “+” or “-” to adjust the hour
Continue to press the “ PROG SET” button, the minute starts blinking
Press the “+” or “-” to adjust minute
(IV) Set the shutdown time
Then press the “ PROG SET” button, the display is off, and the hour starts blinking
Press the “+” or “-” to adjust the hour.
Continue to press the “ PROG SET” button, the minute starts blinking
Press the “+” or “-” to adjust minute
(V) Set temperature
Then press the “ PROG SET” button, and the temperature set starts blinking. At this
moment, the temperature displayed is normally set temperature, which can be
adjusted by pressing “+” or “-”
(VI) Press “ PROG SET” button to continue setting, and press “OK” complete
the setting
6. Timer switch
“TIMER ON/OFF” is to control the timed opening and closing
In the standby mode, when reopen the fireplace, it is can remember the last time
setting.
Note 1: When the week timer is power on, you should turn on the heating function,
or else when the machine is working again, there will be only the flame effect
working.
To Next Page
Loading...
